Home » Archive by category TUTORIALS (Page 15)

[TUTORIAL] How to install OSCAM on EGAMI

Here is a tutorial on the installation and configuration of OScam on the Vu+ decoder under a EGAMI image and OScam. For this tutorial you need. Material: DM900, AX UHD-51, Miraclebox Micro Miraclebox Micro V2 Miraclebox Mini Miraclebox Mini PLUS + Miraclebox Mini HYBRID Miraclebox Twin Miraclebox Twin...
Continue reading

[TUTORIAL] How to install OSCAM modern on NewNigma2

Here is a tutorial on the installation and configuration of OScam on the Dreambox decoder under a NEWNIGMA2 image and OScam. For this tutorial you need. Material: Dreambox, DM520, DM525, DM820, DM7080, DM900, DM920, Dreambox ONE, Dreambox TWO, Dreambox Seven Software: Winscp A OScam subscription If you do...
Continue reading

[TUTO] HowTo flash Image for DM920

1.) Turn on the power switch of DM920 at the back 2.) If LED on the Standby-Button at the front lights up, keep it pressed until LED quickly lights up red and blue 3.) When LED stops blinking then release Standby-Button 4.) After few seconds a info shows...
Continue reading

[TUTO] HowTo flash Image for DM900

1.) Turn on the power switch of DM900 at the back 2.) If LED on the Standby-Button at the front lights up, keep it pressed until LED quickly lights up red and blue 3.) When LED stops blinking then release Standby-Button 4.) After few seconds a info shows...
Continue reading

[TUTO] HowTo flash Image for DM7080HD

1.) Turn on the power switch of DM7080 at the back 2.) Press Power-Button at the front until on display appears “entering setup” 3.) Now you can release Power-Button and DM7080 is in Rescue Mode 4.) You have to enter via browser -> “http://dm7080” (without “” ) or...
Continue reading

[TUTO] HowTo flash Image for DM820HD

1.) Turn on the power switch of DM820 at the back 2.) Press Power-Button at the front until on display appears “entering setup” 3.) Now you can release Power-Button and DM820 is in Rescue Mode 4.) You have to enter via browser -> “http://dm820” (without “” ) or...
Continue reading

[TUTO] HowTo flash Image for DM525HD

1.) Turn on the power switch of DM525 at the back 2.) If LED on the Standby-Button at the front lights up, keep it pressed until LED quickly lights up red and blue 3.) When LED stops blinking then release Standby-Button 4.) After few seconds a info shows...
Continue reading

[TUTO] HowTo flash Image for DM520HD

1.) Turn on the power switch of DM520 at the back 2.) If LED on the Standby-Button at the front lights up, keep it pressed until LED quickly lights up red and blue 3.) When LED stops blinking then release Standby-Button 4.) After few seconds a info shows...
Continue reading